116
SOLID-STATE STEREO PRE-AMPLIFIER
Convert from a crystal to magnetic cartridge.
This high quality Stereo Pre-
Amplifier will allow you to
replace a Crystal or Ceramic
stereo cartridge with a better
quality magnetic stereo car-
tridge while using the original
Stereo amplifier supplied
with your turntable. The use
of this Pre-Amplifier in con-
junction with a magnetic car-
tridge will give you CD quali-
ty sound out of your vintage
turntable. Improved circuitry
and filtering in the power
supply results in lower hum
while maintaining an isolated
ground loop.
SPECIFICATIONS:
Circuit Design:
Low noise Silicon transistor, Printed Circuit
Frequency Response:
30-20,000Hz equalized RIAA.
Input Impedance:
50k ohms
Max. Output:
1.8V (less than 1% distortion)
Output Load:
50k ohms
S/N Ratio:
Over 60db
Power Supply:
117 VAC, 50-60Hz .1 watt
MICROPHONES
ACCESSORIES
NOISE FREE MICROPHONE CABLE
500 ft. Reel
Fully shielded, two conductor cable
with heavy copper braid for bal-
anced line microphones. Heavy-
duty black rubber jacket to meet all
service requirements. This 500 foot
cable, spooled and supplied with a
plastic axle, is contained in a dis-
play / dispenser box for ease of
distribution.
No. EMC160T
- Two Conductor
No. EMC95T
- Single Conductor
Same Specifications as No. EMC160T
RETRACTABLE MULTI-CONDUCTOR CABLE
These retractable cables have stranded copper conductors con-
sisting of 15 strands of 37 AWG wire. The shield has 48 strands of
37 AWG copper wire. Cable O.D. of shields are extended and
tinned for grounding.
(5) Color-Coded Conductors
(1) Shielded, (4) Unshielded
5 ft. Extended, 2 ft. Retracted
No. TEC80
No. TEC820
-
20 ft. extended
(3) Color-Coded Conductors
(1) Shielded, (2) Unshielded
10 ft. Extended, 2-1/2 ft.
Retracted
No. TEC70
(3) Color-Coded Conductors
(1) Shielded, (2) Unshielded
5 ft. Extended, 20 in. Retracted
No. TEC60
No. PRE600
MULTI - COLOR MICROPHONE WINDSCREEN SETS
FOUR SETS OF
INTERCHANGEABLE WIND SCREENS
-BOTH FUNCTIONAL AND DECORATIVE-
Each soft foam screen adds depth and beauty that the entertainer will
find hard to resist. Instant color is added to his/her act. Unwanted
“breath” noise due to close talking is eliminated when windscreen is
slipped over microphone.
POP and WIND Noise usually associated with outdoor use is filtered
out as the foam material is made of open pore urethane foam.
Indoors or out, any microphone can now look different each time - and
sound the same every time. A tip for users of mike mixers - avoid mike
mix -ups.Identify each mixer control with the color of the windscreen on
the microphone it controls.
No. MW1
-
Contains four 1-3/4” high windscreens to fit over 1” to
1- 3/8” Dia. microphones. Colors: Red -Yellow - Green - Black.
No. MW2
-
Contains four 2-3/4” high windscreens to fit over 1-3/8”
to 1- 3/4” Dia. microphones. Colors: Red -Yellow - Green - Black.
No. MW3
-
Contains two 2-3/8” high windscreen to fit over 1-3/4”
to 2” Dia. microphones. Colors: Red - Green.
No. MW4
-
Contains one 2-3/8” high windscreen to fit over 1-3/4” to
2” Dia. microphones. Color: Dark Grey
COMMUNICATION DYNAMIC MICROPHONE
for CB and Amateur Applications
Everyone can now enjoy a microphone with superior specifications at
a moderate price. Features four (4) conductors, (1 shielded), in a 6-
ft. coiled cable designed for relay or electronic switching in transmit-
ters, transceivers and PA amplifiers.
Full size, press-to-talk switch extends over half the length of this
hand-held mike. High impact shockproof case is attractively styled in
matte finish midnight black. Supplied with rear hanger button.
No. CM43A
Specifications:
Directivity:
Omni - Directional
Sensitivity:
-72dB ± 4db at 1KHz
Frequency Response: 200Hz - 5KHz
OFC...,106,107,108,109,110,111,112,113,114,115 117,118,119,120,121,122,123,124,125,126,...352