280
Standard (T1-3/4) LED’s mounted in durable nylon cases and ready to speed mount and eliminate additional mounts
and parts.
6” Stripped Leads
28 Volt Snap-In LED LAMPS for .250” diameter mounting holes
Part No.
Voltage
Description
Terminals
11-2430
28-volt
RED
6” stripped leads
11-2432
28-volt
AMBER
6” stripped leads
11-2434
28-volt
GREEN
6” stripped leads
28 Volt LED Panel Lamp for 1/4” hole size. The series has 6” long black/red lead wires. Lead wires are stripped and tinned for quick soldering
or adding crimp connectors. Body color and molded bezel is black in color.
125 Volt Snap-In LED LAMPS for .250” diameter mounting holes
Part No.
Voltage
Description Terminals
11-2450
125-volt
RED
6” stripped leads
11-2452
125-volt
AMBER
6” stripped leads
11-2456
125-volt
GREEN
6” stripped leads
125 Volt LED Panel Lamp for 1/4” hole size. Use in appliances and similar applications where standard mains voltage is present. The series
has 6” long black/red lead wires. Lead wires are stripped and tinned for quick soldering or adding crimp connectors. Body color and molded
bezel is black in color.
Use of LED Lamp Assembly.
Use this LED Lamp Assembly with the appropriate voltage (see front of card for voltage). NOTE:
Correct polarity must be observed for this device to work properly; connect the red colored wire to
positive and the black wire to the negative.
The 12-14 Volt Lamp Assemblies are intended for use in automobiles and trucks with about
(standard) 13.8 volts (most vehicles). They may, of course, be used in other circuits that provide
voltage in the twelve to fourteen volt range. No additional resistor needs to be used.
The 24-28 volt values are generally used in systems such as control panels. If you plan to use
the lamp assembly with AC, then connect a diode in series with the lamp assembly. No additional
resistor needs to be used.
Two volt LED assemblies are also available from your local supplier. A 2 volt LED may be used
with practically any higher voltage, simply calculate the value of resistor to use in series with the
LED. The 2-volt LED assemblies are supplied with information on each card describing how to
determine the resistor value for both AC and DC with a simple formula or by following a chart.
Above; Typical AC circuit using a
diode. The “R”, or resistor is not
necessary for 12-14 or 24-28 volt
assemblies when they are used @
rated voltages.
6” Stripped Leads
12-14 Volt Snap-In LED LAMPS for .250” diameter mounting holes
Part No.
Voltage
Description
Terminals
11-2420
12-14 volt
RED
6” stripped leads
11-2422
12-14 volt
AMBER
6” stripped leads
11-2426
12-14 volt
GREEN
6” stripped leads
6” Stripped Leads
12-14 Volt LED Panel Lamp for .25” hole size. This series has typical LED
(T1-3/4”) Size. Lead wires are 6” long, stripped .380” on ends (red and black
insulation indicates polarity).
PANEL LAMPS & INDICATOR LIGHTS
LED
OFC...,270,271,272,273,274,275,276,277,278,279 281,282,283,284,285,286,287,288,289,290,...352