COMMUNICATION MICROPHONE, dynamic Model no. CM43A. For use with two way radios such as CB, business
or Amateur Radios. Four wire plus one shield six foot coiled mike cord. May be
used for either relay or electronic switching rigs. Tough, high-impact plastic
case and PTT switch, color: black. Frequency response is 100 to 10,000 Hz,
sensitivity is -70db and the impedance is 500 ohms. Moderate price and good
performance.
S.W.R BRIDGE, POWER AND FS METER model no. FS45 Modestly priced for a unit that may be used up to
150mHz, measure both S.W.R. (standing wave ratio) and field strength. Compact
size: 5-1/4"H X 2-1/4"D X 1-15/16". Measures power in two ranges,
1/2 to 10 watts and 100 watts. Field Strength (FS) antenna included.
MIKE-CLIP, or microphone hanger/holder.
A stainless steel clip that
can be attached (with sheet metal screws, included) to dashboard of car, side of
radio, shelf in Ham shack etc. to hold a hand mike when it is not in use.
Mounting hardware is included. Holds fast during off-road too.
Part no. HS200SS
replacement RADIO and SCANNER MOUNTING SCREWS
Large thumb-screw mounting screws, typically found with mobile radios. Three
sizes are available and they are packaged two per part number (i.e. order one of
the part number and you will receive one package of two screws). These are
machined brass with a nickel plate. Threaded part is 3/8" long. Three different
diameters are available.
Part no.
Size
K40
4mm
K50
5mm
K60
6mm
For fuses, in-line fuse holders etc. for use with mobile radios, be sure to
see the "fuses" page.